Making Gold Leaf Candles and Stenciled Pillars

Making the Gold Leaf Candles:
What you will need:
-Felt tip marker
-Tracing paper
-Masking tape
-Sheets of gold leaf
-Pillar candle
-Ballpoint pen, pencil or skewer
Using marker, draw desired motifs on the tracing paper. Tape gold leaf, with the gold side down to the candle. Tape the motif over the gold leaf paper. Using a pen, draw over motif to transfer the gold leaf to the candle on the outside. Peel back the gold leaf to insure entire motif has been transferred onto the entire section you are wanting on your candle. Remove motif and gold leaf as well. Using a fresh sheet of gold leaf, repeat taping and transferring motifs to cover the entire candle, if you choose. Do not place tape over the areas where the gold leaf has been applied.
Making the Stenciled Pillars:
What you will need:
-Candle
-Ruler
-Stenciled plastic
-Pencil
-Crafts
-Knife
-Spray Stencil Adhesive
-Nontoxic spray paint
Measure height and circumference of candle; mark the dimensions on stencil plastic. Draw design on the plastic to fit inside the outlines. Cut out parts of design to make the stencil.
Spray back of stencil with adhesive; press onto candle. Spray candle with paint; let dry. Remove the stencil once the paint is dry. To finish the candle spray finished candle with the stencil dried completely with candle gloss spray. If you stick to smaller stencils they will show up and be seen easier than larger stencils. So choose wisely. This an other tools needed to make these are available at any hobby or craft store worldwide,

Leave a Reply